Operating modes
The carpet comes preconfigured to be controlled by the SHX system although it is possible to configure it for use in passive mode where the fiber changes color fusing the RGB colors with a smooth and slow transition.
SHX Mode
Make the DMX connections: for use with the SHX system, the DMX cable must be connected to the DMX IN connector. This cable must be connected to the rest of the DMX bus of the installation. In the event that this element is the last of the entire installation, the bus terminator should be connected to the DMX OUT (this terminator is supplied in the SHX Central Device). If you must continue the DMX signal to another device, you must connect the DMX cable to the DMX out connector.
Likewise, the DMX address must be configured using the microswitches as shown in the figure (address 224):
Pasive Mode
For use in passive mode the microswitches must be configured as follows:
Plug th device
It must plug the light source. On the one hand the feeder must be connected to the light source as shown in the figure and on the other side the feeder must be connected to the electric current.