The fibre optic ceiling creates an amazing effect of shining stars. The stars change color randomly to create a magical effect that is ideal for working on color recognition and for activities that boost communication.
Supplied with a mounting board measuring 200 x 100 cm, a lightsource and fixing screws.
This star ceiling is the model used for rooms with the SHX System, and offers unlimited control options using any of the SHX elements: choose any color or even change the color of the tube using your voice or depending on the color of the image being projected.
1. 2. 3.
Necessary elements for assembly:
For the assembly of the device you will need the following items not included with the product:
For fastening the curtain:
IMPORTANT: check if the surface where the product is to be fixed is safe and suitable
Hang the fiber ceiling
For fixing the roof, there are 6 adjustable steel cables. For the suspension of the panel, the anchor points must be marked on the roof of the room and the screws must be installed to hang the panel. Depending on the height of the roof, the length of the steel cable must be adjusted. Once adjusted, all the flange nuts should be tightened tightly.
IMPORTANT: the flanges are pre-assembled, but they are not fixed permanently. Before hanging the shower they should be tightened and make sure they are firmly attached.
The ceiling comes preconfigured to be controlled by the SHX system although it is possible to configure it for use in passive mode where the fiber changes color fusing the RGB colors with a smooth and slow transition.
Make the DMX connections: for use with the SHX system, the DMX cable must be connected to the DMX IN connector. This cable must be connected to the rest of the DMX bus of the installation. In the event that this element is the last of the entire installation, the bus terminator should be connected to the DMX OUT (this terminator is supplied in the SHX Central Device). If you must continue the DMX signal to another device, you must connect the DMX cable to the DMX out connector.
Likewise, the DMX address must be configured using the microswitches as shown in the figure (address 224):
For use in passive mode the microswitches must be configured as follows:
Plug th device
It must plug the light source. On the one hand the feeder must be connected to the light source as shown in the figure and on the other side the feeder must be connected to the electric current.
Before start using the device
Check the following points:
Use of the product
The control of this device has been added to the SHX application.
The configuration parameters for this device are:
In the SHX application it has been created within the DMX devices with the following configuration:
Private users can contact the establishment where they purchased the product or with the relevant local authorities to find out how and where they can take it to be subjected to environmentally friendly and safe recycling.
Within the legal warranty period we agree to rectify for free by repairing or replacing defects in the product derived from defective materials or manufacturing defects.
Any unauthorised alteration or modifications to the product will void this warranty.
If you find any damage or any material is missing please contact our technical service for assistance.
Any damage or breakage caused during transport must be notified within three days of receipt.