Ultraviolet light allows to create special environments where the reflective elements stand out completely, facilitating attention and opening a new world of possibilities.
A powerful ultraviolet bulb lights in a determined area of the room for a long-lasting time.
BJ-234 Enabler Socket+
Unpack the product carefully.
If you find any damage or lack of material when unpacking, please contact BJLive!. It is recommended to keep the boxes during the period of warranty in case it’s be necessary to return it.
To fix the SHX UV LED light, you will need the following items (not included with the product):
The UV light can be mounted on wall or ceiling. It must be installed at a distance of at least 0.5m from the surface to be illuminated.
A separation of 30cm should be left between the ventilation grille and the wall or ceiling.
Do not install the barrel in the following places:
For mounting, the light has a base with 1 hole. For its installation:
STEP 1. Fix the UV light
Use the handle to mark the fixing hole.
Make a hole on the wall or ceiling and fix the base.
Fix the bulb with the fixing screw. Remember to put the washer between the screw and the bulb holder.
Do not cover the ventilation holes of the device.
STEP 2. Connect the power adapter.
Before connecting the feeder, check if the Socket + receiver is properly configured. The position of the wheels of the receiver must be:
To start up the UV LED spotlight you can do it from the SHX application or through an external switch.
With the configuration delivered from the factory, when activating the UV light, it will change its state.
To activate the UV light from the SHX application, go to the “Control” tab of the SHX application:
As indicated in the previous figure, by clicking on the UV icon it will activate the light when is OFF, and will turn in off if is ON.
IMPORTANT: For the correct operation of the device, the blue wheel of the Socket + device must be in the position 5
To control the fan, there’s a specific configuration for the device created on SHX application.
The control orders of the fan are sent by radiofrequency. The codes associated with the different functions of the fan control are:
The configuration parameters of the UV LED light are:
In the event of the UV LED light not starting up, check the following steps:
IMPORTANT:check if the bulb is in AT01 mode (see section “Start-up of this manual)
There is a problem in the LED panel. You should contact your distributor.
There is a problem on the LED panel. You should contact your distributor.
The emission of ultraviolet light from this LED light is not harmful, althought it’s recommended to avoid direct eye contact and to kee`a safety distance from the light.
The recommended distance to the work at safeway is between 2 and 2.5m.
White elements and fluorescent colors are especially noticeable when working under UV light.
Electrical products should not be disposed of with household waste
Within the legal warranty period we agree to rectify for free by repairing or replacing defects in the product derived from defective materials or manufacturing defects.
Any unauthorised alteration or modifications to the product will void this warranty.
If you find any damage or any material is missing please contact our technical service for assistance.
Any damage or breakage caused during transport must be notified within three days of receipt.